How to Replace the Wheels on Your Floor Jack Easily and Quickly

Floor Jack Wheel Replacement is a common job for do-it-yourselfers, and is a relatively simple process. Floor jacks are used to raise a vehicle up off the ground in order to perform maintenance or repairs, and are essential for any home garage. If the wheels of your floor jack have become worn or damaged, it’s important to replace them as soon as possible for safety reasons.

Tools and Materials Needed

Before beginning, you’ll need to make sure you have the right tools and materials on hand. These include:

  • Floor jack
  • New wheels
  • Screwdriver
  • Socket set
  • Wrench
  • Pliers
  • Grease

Step-by-Step Guide

Step 1: Lift the Vehicle

Begin by placing the floor jack underneath the vehicle and raising it off the ground. Make sure that the jack is securely in place, and that the vehicle is stable before continuing.

Step 2: Remove the Old Wheels

Once the vehicle is off the ground, you’ll need to remove the old wheels. Start by removing the bolts or screws that are holding the wheels in place. Use a screwdriver, socket set, or wrench, depending on the type of fasteners used. Once all of the fasteners have been removed, the wheels should be able to be pulled off by hand.

Step 3: Install the New Wheels

Once the old wheels have been removed, you can install the new ones. Start by applying a thin layer of grease to the axle and the wheel hub, then place the wheel onto the axle. Make sure that it is secure, then use the same fasteners to reattach the wheel to the axle.

Step 4: Test the Wheels

Once the new wheels have been installed, it’s important to test them to make sure that they are secure and functioning properly. Start by lowering the vehicle back onto the ground, then use the jack to raise it back up. If the wheels are secure and functioning properly, the vehicle should raise up easily.

Step 5: Clean and Lubricate

Once the wheels have been tested and are functioning properly, you’ll need to clean and lubricate them. Start by wiping off any excess grease, then apply a thin layer of lubricant to the axle and wheel hub. This will help to ensure that the wheels are able to move smoothly and will extend their life.


Replacing the wheels on a floor jack is a relatively simple process, and can be done in just a few steps. By following the steps outlined above, you should be able to replace your floor jack wheels quickly and easily. Remember to always use caution when working with a floor jack, and make sure that the vehicle is stable before proceeding.

Written by Best Floor Jack

Leave a Reply

Your email address will not be published. Required fields are marked *

GIPHY App Key not set. Please check settings

5 Creative Floor Jack Storage Solutions for Your Garage

How to Choose the Best Hardwood Floor Jack for Your Home